NastyDLA – some tape delay fun

To make up a complete and sustaining sequence out of  some melodic pattern is a standard task for the electronic musician. The good old tape delay is his best friend then, providing not only consistent and sustainable echos which are glueing nicely with the original signal but also offering some realtime modulation possibilities as well, to animate some maybe rather static sources.

In this short demo a static pattern is used and NastyDLA is going to be in charge as a tape delay replacement. The chorus is not used in this example but the plug-ins coloring possibilities are shown to some extend: After some bars the timbre of the delay feedback loop changes to a higher pitch and then to a lower one (and vice versa) while simultaneously the feedback amounts are going to change. To the end when the pattern stops, the “tape speed” is slowed down first and accelerated back again afterwards to demonstrate its artifact-free modulation capabilities.

Note how smooth the saturation behaves when driven into self oscillation w/o the usual amount of aliasing artifacts. The delay line generation in this example is set to “dual mono” mode (with 8th to the left and dotted 8th to the right) and the time modulations can be done separate per channel. All animations were done in realtime with host automation and in general all plug-in parameters can be automated in the host.